Avanti RM4401W Betriebsanleitung PDF herunterladen (Seite 15)

EMI/EMC Statement and Manufacturer’s Declaration

This equipment has been tested and found to comply with the limits of EN 60601-1-2.

These limits are designed to provide reasonable protection against harmful interference in both a

medical and residential environment. This equipment generates, uses and can radiate radio frequency

energy and, if not used in accordance with manufacturer’s instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception or other

equipment, which can be determined by turning the equipment off and on, the user is encouraged to try

to correct the interference by one of the following measures:

l Reorient or relocate the receiving antenna.

l Increase the separation between the equipment.

l Connect the equipment to an outlet on a circuit different from that to which the receiver or equipment

was connected.

The equipment having been tested to operate within the limits of electromagnetic compatibility.

(Immunity to interference from nearby sources radiating radio frequency energy). Sources exceeding

these limits may give rise to operation faults. Where possible the system will sense the interference and

if it is of short duration transparently take countermeasures whilst operating near normally, or failing

this will issue a warning and take measures for the continued safely of the user. Further increased levels

of energy may cause the system to stop operating, continuously generate random faults or continuous

resets.

Try to ascertain the source of the interference by turning nearby or suspect equipment off, and see if the

interference effects stop. In any such event the user is encouraged to try to correct the interference by

one of the following measures:

l Have the interfering equipment repaired or replaced.

l Reorient or relocate the interfering equipment.

l Increase the separation between the equipment and the possible source of the interference.

l Connect the equipment to an outlet on a circuit different from that to which the interfering equipment

was connected.

Information regarding Electro Magnetic Compatibility (EMC) according to IEC60601-1-2, clause 6.8

With the increased number of electronic devices such as PC’s and mobile telephones, medical devices

in use may be susceptible to electromagnetic interference from other devices. The EMC (Electro

Magnetic Compatibility) standard IEC60601-1-2 defines the levels of immunity to these electromagnetic

interferences. From the other hand, medical devices must not interfere with other devices. IEC60601-1-

2 also defines the maximum levels of emissions for these medical devices. The VENTURI

conforms to

this IEC60601-1-2 standard for immunity and emission. Nevertheless, special precautions need to be

observed:

l The VENTURI

needs to be installed and put into service according to the EMC information below.

lThe VENTURI

is intended for use in the electromagnetic environment specified in the tables below.

The user of the VENTURI

should assure that it is used in such environment.

l In general, although the VENTURI

complies to the EMC standards, it can be affected by portable

and mobile RF communications equipment (such as mobile telephones).

lThe VENTURI

should not be used adjacent to or stacked with other equipment. In case adjacent or

stacked use is necessary, the VENTURI

should be observed to verify normal operation.

Guidance and Manufacturer’s Declaration: Electromagnetic Emissions (IEC 60601-1-2)

Emissions Test Compliance Electromagnetic environment - guidance

RF emissions CISPR 11 Class B

The VENTURI

systems are suitable for use in all establishments,

including domestic establishments and those directly connected to

the public low-voltage pump supply network that supplies buildings

used for domestic purposes.

Harmonics emissions 61000-3-2 Class A

Voltage uctuations / icker emissions 61000-3-3 Complies

1 2 ... 10 11 12 13 14 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

Avanti RM4401W Betriebsanleitung Seite 15

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Avanti RM4401W